Maximus Initial Assembly

I’ve just unboxed and attempted to assemble the full size Maximus bar clamp.

The clamp end that has the threaded adjustment handle is shipped with the threaded part, for shipping reasons I would think, separate from the clamp body. The problem I am having is removing the swivel foot from the threaded shaft; thus not allowing the shaft to be installed into the body. I’m sure that it is something very simple, but my simple mind just won’t figure it out.

Thank you, Jeff Eilenberger

It’s easy, just pull the foot straight off the end.

the foot should be oriented straight in line with the threaded spindle when pulling it off, there’s a small steel snap ring in a groove that will bind if it’s tilted when pulling off

Thank you very much